In the production of plywood, a lot of varieties of colors are derived, the most important of which is to paste a thin layer of decorative veneer thin wood on the surface of the original plywood, called decorative veneer veneer plywood, referred to as decorative board or veneer in the market.
It is worth noting that common veneer panels are divided into natural wood veneer veneer and artificial thin wood veneer. Natural wood veneer is a thin veneer made from precious natural wood by planing or rotary cutting processing methods. Artificial thin wood is made of relatively low-cost logs rotary cut into veneer, glued into wood square by a certain process, and then planed into decorative thin wood with beautiful patterns.
Usually, the veneer veneer attached to the natural wood veneer veneer is often a tree species with good patterns and high value, such as cypress, oak, rosewood, ash, etc. However, it should be stated in the trade name, for example, "cypress veneer plywood", or "ash chip plywood", or "cherry wood veneer". The terms "veneer", "slice" and "trim" all reflect the basic characteristics of "veneer". However, it cannot be abbreviated as cypress plywood, ash plywood, etc., because these abbreviations refer to the fact that the panels and bottom plates of plywood are made of cypress or ash. Another problem is that there is an increasing number of furniture produced by veneer, and although these furniture have the appearance of "cypress" and other wood grains, the wood of the furniture is generally made of other woods.
